Model Specification - HP The statement below may be inserted into a specific job specification to help maintain engineering standards and ensure project integrity. The cleaning solvent shall be at least 80% high purity, dearomatized, aliphatic hydrocarbon enhanced with a cyclic terpene. Aromatic content shall be less than 1%. Water content shall be less than 75 ppm. The cleaner shall not leave a residue. The cleaner shall not significantly affect the volume resistivity of Union Carbide 0691 XLPE cable insulation shield. The cleaner shall show a voltage withstand of t least 40 kV before breakdown. The cleaner shall not significantly affect the tensile and elongation properties of XLPE, silicone rubber, and EPDM rubber when tested to guidelines proposed in IEEE P1493. When wiped over an XLPE (Union Carbide Type 0691) insulation shield, a clean towel wetted with the cleaner shall become visibly “black” with two wipes over 2-inches of cable length with light hand pressure. The cleaner shall not be a carcinogen or listed by CERCLA as a hazardous waste. It shall not be on the EPA Phase I or Phase3 II list of banned or phased-out chlorofluorocarbons.